Skip to content
Photopolymers for DLP Printers

RadSys3D

DENTAL

DENTAL

JEWELRY

JEWELRY

RAPID
PROTOTYPING

RAPID
PROTOTYPING

Products

DigiCAST 100

DigiCAST 100 is a castable photopolymer designed to be used on bottom-up projection systems.

  • Printable from 25 to 100 microns on lamp projection systems
  • Extremely high print quality
  • Extremely low shrinkage
  • Flexibility and stress resistance
  • Low viscosity
  • Excellent burn-out behavior
  • Color-changing upon post-curing
RadSys3D

DigiCAST 200

DigiCAST 200 is a castable photopolymer designed to be used on top-down projection systems.

  • Extremely high print quality
  • Printable from 50 to 100 microns
  • Extremely low shrinkage
  • Good mechanical strength
  • Low viscosity
  • Excellent burn-out behavior
  • Color-changing upon post-curing
RadSys3D

DigiCAST CH4

DigiCAST CH4 is a broadband UV/Visible castable photopolymer designed to be used on both bottom-up and top-down projection systems.

  • High print quality
  • Printable from 50 to 100 microns
  • Extremely low shrinkage
  • Good mechanical strength and post-cure response
  • Low viscosity
  • Excellent burn-out behavior
  • No color change after post-cure
  • Suitable for Stone on Resin
RadSys3D

DigiTUF 4000/4100

DigiTUF 4000 and DigiTUF 4100 are UV/Visible hard photopolymers for both top-down and bottom-up projection systems. It is mainly used for making rubber molds and models.

  • High print quality
  • Printable from 50 to 100 microns
  • Moderate viscosity
  • Balanced hardness and toughness
  • Very low adhesion to liquid rubber
RadSys3D

DigiTUF 5000/5100

DigiTUF 5000 and DigiTUF 5100 are UV/Visible tough photopolymers for both top-down and bottom-up projection systems. It is mainly used for making rubber molds and models.

  • High print quality
  • Printable from 50 to 100 microns
  • Moderate viscosity
  • Very high toughness
  • Very high toughness
  • Very low adhesion to liquid rubber
  • Thermoplastic behavior
RadSys3D

DigiTUF Crystal

DigiTUF Crystal is a UV tough photopolymers for bottom-up projection systems. It is mainly used for making clear and transparent models.

  • High print quality
  • Printable from 50 to 100 microns
  • Moderate viscosity
  • High toughness
  • Transparent and Colorless
RadSys3D

Packaging

The standard packaging of all RadSys3D photopolymer resins is 1 kg black plastic bottles.

The bottles are packed in an anti-counterfeiting paperboard box.

The box and the security hologram must be intact, when you receive the resin package.

All the Services You Expect From RadSys3D

Contact Information